Installation; Safety Measures; Operation; External Power Supply - Pulsar XQ30 Handbuch

INSTALLATION:

Remove the protective cover from the Battery Pack.
Lift the lever (13).
Install the battery into the dedicated slot on the sight housing so that
element F (Pic.2) appears from below.
Fix the battery by clicking the lever.

SAFETY MEASURES:

Only use the charger supplied with the Battery Pack. The use of any
other charger may irreparably damage the Battery Pack or the
charger and may cause fire.
Do not leave a battery unattended while charging.
Never use a modified or damaged charger.
Charge the Battery Pack at a temperature ranging from
0 °C to +45 °C.
Do not leave the Battery Pack with a charger connected to the mains.
longer than 24 hours after full charge.
Do not expose the battery pack to high temperature or to a naked
flame.
Do not submerge the battery in water.
Do not connect external sight with a current consumption that
exceeds permitted levels.
The Battery Pack is short circuit protected. However, any situation
that may cause short circuiting should be avoided.
Do not dismantle or deform the Battery Pack.
Keep the battery out of the reach of children.
7

EXTERNAL POWER SUPPLY

The sight can be powered with an external power supply such as Power
Bank (5V).
Connect the external power supply to the USB port (10) of the sight
(Pic. 1).
The sight switches to operation from external power supply, and the
IPS5 Battery Pack will begin slowly charging.
6 7
The display will show the battery icon
percentage.
If the sight operates on external power supply but the IPS5 battery is
not connected, the icon
When the external power supply is disconnected, the sight switches
to the internal battery pack without powering off.
8

OPERATION

INSTALLATION OF MOUNT
Before using the sight you need to install a mount (may not be
included).
The mounting holes (14) in the base of the sight enable the mount to
be installed in one of the multiple positions. The choice of the
mounting position helps the user to ensure the correct eye relief
depending on the rifle type.
Attach the mount to the base of the sight using a hex-nut wrench and
screws.
Install the sight on the rifle and check if the position is suitable for you.
If you are happy with its position, remove the sight, unscrew the
screws halfway, apply some thread sealant onto the thread of the
screws and tighten them fully (do not overtighten). Let the sealant dry
for a while.
The sight is ready to be installed on a rifle and to be zeroed.
After first installation of your sight on a rifle, please follow instructions
in the section "Zeroing".
WARNING! Do not point the objective lens of the unit at intensive
sources of light such sight emitting laser radiation or the sun. This
may render the electronic components inoperative. The warranty
does not cover damage caused by improper operation.
WARNING! The radiator cooling system (9) becomes warm during
operation: this is normal and allows an increase in the sensitivity of
the sight.
with charge level as a
is shown.
8