Status Bar - Pulsar XQ30 Handbuch

Press the M button, countdown starts (30 sec),
=
within which hold down for two seconds any RC
button.
If activation is successful, the message
=
«Connection complete» appears.
occurs the message «Connection failed»
appears. Repeat the procedure.
The RC is activated and ready for use.
When operating a thermal sight, defective (dead)
pixels (bright or dark dots with constant brightness)
may become visible on the sensor. Thermal sights
Defective
allow the user to repair defective pixels on the
pixel repair
detector using a software-based method or to abort
deletion.
Enter the main menu with a long press of the M (4)
=
button.
Enter the submenu "Defective pixel repair" with a
=
short press of the M button.
Select icon
=
A marker
=
On the right side of the display appears a
=
"magnifying glass" – a magnified image in a frame
with a fixed cross,
detection of a defective pixel and to match the
pixel with the marker, horizontal and vertical
arrows for X and Y axes showing marker's
movement.
With a short press of the UP and DOWN buttons
=
move the marker to align it with a defective pixel.
Switch the direction of the marker from horizontal
=
to vertical and vice versa with a short press of the
M button.
Align the defective pixel with the fixed cross in the
=
frame – the pixel should disappear.
Delete the defective pixel with a short press of the
=
REC (6) button.
A brief message "OK" appears in the frame in
=
case of success.
Then you can delete another defective pixel by
=
moving the marker along the display.
Exit "Defective pixel repair" option with a long
=
press of the M button.
23
If error
+
with a short press of the M button.
appears on the left side of the display.
designed for easier
x=95
y=99
Return to default defective pixel pattern
This option allows you to cancel deletion of the
defective pixels and return them to the original
state.
Enter the main menu with a long press of the M (4)
=
button.
Enter the submenu "Defective pixel repair" with a
=
short press of the M button.
Select icon
=
Select "Yes" if you wish to return to default
=
defective pixel pattern, or "No" if you do not.
Confirm selection with a short press of the M
=
button.
This option allows the user to view the following
Info
information about the sight:
Full name
=
SKU number
=
serial number
=
software version
=
hardware version
=
service information
=
Enter the main menu with a long press of the M (4)
button.
Enter the submenu "Info" with a short press of the M
button.
14

STATUS BAR

The status bar is located in the lower part of the display and shows
information on the actual operating status of the sight, including:
Image inversion mode (only Hot Black)
Actual zeroing profile (for example А)
Zeroing distance (for example, 300 m)
Operating mode (for example, Forest)
Calibration mode (in the automatic calibration mode, three seconds
before automatic calibration a countdown timer
in place of the calibration mode icon). The timer appears only as soon
as the operating temperature of the microbolometer is stabilized (in
5-7 minutes of continuous operation of the sight). Upon start of the
sight the shutter is actuated automatically without showing the timer.
Current full magnification
and press М.
00:01 is shown
24