Protocols; Baud-Rate; Rs-485 Connector - Santec VDC-610ID Bedienungsanleitung

6.3 Protocol
DIP switch DIP SW 7 and DIP SW 8 are used for protocol settings.
Factory default: Pelco-D or Pelco-P (automatic recognition)
DIP SW 7
OFF
6.4 Baud rate setting
DIP switch DIP SW 9 is used for Baud rate setting.
DIP SW can be set to 2400bps or 9600bps.
Factory setting: 2400bps
DIP SW 9
OFF
ON
6.5 RS-485 connection
DIP switch DIP SW 10 is used for 100 Ω connector.
Only the keyboard of the final camera must be connected to DIP switch 10. Even if only one
camera is used, it has to be connected to DIP switch 10.
_________________________________________________________________________________
DIP SW 8
OFF Pelco-D or Pelco-P
Baud rate
2400
9600
- 60 -
Bedienungsanleitung / User manual VDC-610ID/W