Dome Settings - Santec VDC-610ID Bedienungsanleitung

Bedienungsanleitung / User manual VDC-610ID/W

5.2 Dome settings

If the cursor is positioned on „Dome Set", move the joystick right to open the dome
settings.
Dome Set: Camera ID:
The camera ID may consist of 16 digits. Select the digits by moven the joystick left or
right. To move from left to right to the next digit, press ZOOM TELE. To move from
right to left to the next digit, press ZOOM WIDE.
Blanks are marked with a .
Dome Set: Recover:
The dome camera is able to recover the last settings before the camera has been
operated manually (auto scan, group tour, preset, pattern or sectors). In case the
camera had been switched off, it starts operations again after the defined time.
The recover time may take 15 to 99 seconds.
Default setting is OFF.
Dome Set: Manual Speed:
Manual pan/tilt speed can be set from 100°/sec to 150°/sec.
Default setting is 100°/sec.
Dome Set: Auto-Flip:
The camera provides auto flip function. To enable/disable this function, move the
joystick left/right. Default setting is OFF.
You may also press 67+ „Preset".
Dome Set: Zoom Speed:
Zoom speed can be set to FAST or SLOW. Move the joystick right to make your
selection.
Default setting is FAST.
_________________________________________________________________________________
- 45 -
Default settings