Textron Ransomes Super Certes 51 Sicherheits Und Bedienungs Anleitung Seite 31

Fig. 31
Fig. 32
BRUSH AND COMB SET (Fig. 31)
According to conditions a brush or comb can be fitted.
It is not advisable to use the brush in wet conditions.
To fit either of these units:
1. Remove bolt (A) on both sides of the front
roll.
2. Replace the bolt together with the bracket (B)
in between it and the side plate, replace the
outside locknut and tighten securely.
3. Slacken the nuts (C) at each end of the
brush or comb.
4. Slide the screwed studs into the brackets.
5. Tighten the nuts firmly.
NOTE: The washer should be placed immediately
behind the nuts.
The brush or comb can be moved up or down to suit
varying conditions but always ensure that the unit is
level before re-tightening the nuts.
If the bristles of the brush, through continuous use,
wear at an angle, reverse the brush unit in its frame.
NOTE: It is not necessary to remove the brackets to
remove the brush or comb.
TRANSPORT WHEELS (Super Certes only)
(Fig. 32)
These wheels are driven off the extension of the rear
roll spindle.
To fit or remove wheels:
1. Raise the rear roll clear of the ground by
means of the kickstand.
2. Remove the quick release pins (A).
3. Fit or remove the wheels as required.
GB
GB-29