Cylinder Clutch Adjustment - Textron Ransomes Super Certes 51 Sicherheits Und Bedienungs Anleitung

Fig. 20
Fig. 21
Fig. 22
Fig. 23
MARQUIS: CYLINDER TO BOTTOM BLADE
ADJUSTMENT (A Fig. 20)
To check that the cutting cylinder is correctly to the
bottom blade, tilt the machine back, hold a thin piece of
paper between the edge of the blade and spiral cutters
and turn the cylinder manually.
The paper should be cut cleanly along the length of the
bottom blade, if not, some adjustment is necessary,
BUT DO NOT OVER TIGHTEN.
Adjustment is made by turning the adjustment screws
(A) clockwise to move the cylinder closer to the blade.
It is recommended that an 1/8 of a turn is made
alternately to each adjusting screw, checking frequently
with the paper until the correct setting is achieved.
SUPER CERTES/SUPER BOWL: CYLINDER TO
BOTTOM BLADE ADJUSTMENT (Fig. 21)
To check that the cutting cylinder is set correctly to the
bottom blade: tilt the machine back, hold a thin piece of
paper between the edge of the blade and spiral cutters
and turn the cylinder manually.
The paper should be cut cleanly along the length of the
bottom blade, if not some adjustment is necessary
BUT DO NOT OVER TIGHTEN - the cylinder must be
able to turn freely.
Adjustment is made by loosening the locknut (A) and
turning the adjustment screws (B) clockwise to move
the cylinder towards the blade.
It is recommended that an eighth of a turn is made
alternately to each screw, checking frequently with the
paper until the correct setting is achieved.
WARNING
Turn petrol tap to the "OFF" position before tilting
the machine rearwards.
LANDROLL CLUTCH (Fig.22)
The Landroll clutch should be disengaged when the
OPC lever is released.
To adjust:
1. Release the locknuts (C) on the adjuster at
the lower end of the control cable.
2. Screw the adjuster (A) until there is a gap of
approximately 1mm (3/64in) between the
end of the operating pin and lever.
3. When the correct adjustment has been made
retighten the locknuts.

CYLINDER CLUTCH ADJUSTMENT

61cm (24in) machine only (Fig. 23)
The adjustment of the cylinder clutch is made with the
clutch in the engaged position. slacken the two nuts
(B) either side of the plate, then turn them both in the
same direction until the correct adjustment has been
made. Retighten the nuts.
GB
GB-23