Handle Adjustment; Marquis: Side Rolls - Textron Ransomes Super Certes 51 Sicherheits Und Bedienungs Anleitung

GB-26
Fig. 27
Fig. 28
Fig. 29
NOTE: During the 'backlapping' operation regular
checks should be made on the setting of the cutting
cylinder to the bottom blade and if necessary slight
adjustments made.
When the cutters have been sharpened satisfactorily
they will cut the paper cleanly along the length of the
bottom blade.
WIPE OFF ALL TRACES OF THE CARBORUNDUM
PASTE.
* Obtainable from most automobile service stations.

HANDLE ADJUSTMENT

The height of the handle can be adjusted two ways to
suit the operator.
Where the tubes are attached to the side frames
(A Fig. 28) and where the handlebars are attached to
the lower handle tube (A Fig. 27)
To adjust the height:
1. Slacken the clamp bolts (A Fig. 27 and/or
28).
2. Move the handle to the required height.
3. Retighten the bolts.
IMPORTANT If handlebars are adjusted where they
attach to the lower handle tube, the throttle cable may
need adjusting at (B Fig.27) to obtain the correct
engine speed.

MARQUIS: SIDE ROLLS

(Fig. 29)
To allow long grass to the cut, the centre sections of
the front roll can be removed as follows:
1. Unscrew the bolts and remove spindle and
rolls.
2. Insert split pins into the spindle, position
washers and outer rolls.
NOTE: Split pins and washers are supplied with the
machine.
3. Reassemble.
GB