Led Indicating Panel (Part No. 804791) - Honeywell Esser Bedienungsanleitung

Operating and Installation Instruction LED Indicating Panel
8.2

LED Indicating Panel (Part No. 804791)

The LED Indicator Panel is connected directly via the built-in esserbus
®
esserbus or esserbus
Applying the supply power to a not programmed esserbus
optocoupler may lead to undefined states of the indicator LED.
The esserbus
8000 of the fire alarm control panel .
•
The external power supply U
•
Observe the instruction for connecting the analog loop
(refer to terminal connection X7, terminal -UL
•
The cable shielding must be connected for EMI protection
•
Non-assigned LED outputs must be programmed as >unused> with the programming
software tools 8000 from version V1.09
Ribbon cable to the
LED Indicating Panel
LED No 17 - 32
29 28 27 26 25 24
esserbus ® transponder 32 outputs
Remove jumper
when Isolator board
is used!
10 11 12 13 14 15 16
Ribbon cable to the
LED Indicating Panel
LED No 1 - 16
Abb. 6: Terminal assignment of the built-in esserbus
(only LED Indicating Panel Part No. 804791)
14
®
PLus loop of the fire alarm system 8000 / IQ8Control.
®
transponder is programmed via the programming software tools
and 0 V / GND must be connected to the terminal X8 only
b
23 22 21 20 19 18 17
X9.2
X9
Isolator
788612
X9.1
X4
-UL )
(IN) (OUT)
+12 V
X5
X7
U b
X8
0 V / GND
®
transponder
®
transponder to the
®
transponder with 32
B
A
FB 796670 / 06.09