Product Description; General Information; General Safety Instructions - SOMFY ilmo 50 WT Gebrauchsanleitung

Ilmo 50 WT_5050496X00_multi_6-corr.qxd
Installation instructions

Product description

The ilmo 50 WT motor is non-adjustable: a simple connection is all that is required. The ilmo
50 WT motor programs its end limits automatically.
The ilmo 50 WT motor is designed to drive roller shutters fitted with rigid links and end stops
selected in accordance with the operating conditions described below.
The ilmo 50 WT motor can be mounted either on the right or the left. It can be controlled
from a control point with a fixed position or momentary action-type switch.
Safety

General information

• This Somfy product must be installed by a professional motorisation and home automa-
tion installer, for whom these instructions are intended.
• Before installation, check that this product is compatible with the associated equipment
and accessories.
• These instructions describe how to install, commission and use this product.
• Moreover, the installer must comply with current standards and legislation in the country
in which the product is being installed, and inform his customers of the operating and
maintenance conditions for the product.
• Any use outside the sphere of application specified by Somfy is not approved. Such use,
or any failure to comply with the instructions given herein will invalidate the warranty,
and Somfy refuses to accept liability.

General safety instructions

The safety instructions that must be observed, besides the usual rules, are explained in
these instructions and in the attached "Safety Instructions" document.
Never immerse the
motor in liquid!
Avoid impacts!
Always make a loop in the power supply cable to pre-
vent water entering the motor!
Copyright © 2007 Somfy SAS. All rights reserved - V0 - 12/2007
6/12/07 9:36 Page 17
Do not drop it!
Never drill holes in the
motor!
ilmo 50 WT
- 17 - 17