Charge Battery; Used Batteries; Working With The Lawnmower; Cleaning, Maintenance And Storage - Grizzly ARM 4041 Lion Set Originalbetriebsanleitung

Charge battery

Allow a freshly charged battery
(7) to cool down for approx. 15
minutes before inserting it into the
battery charger (8).
1. Remove the battery (7) from the
H
appliance, as necessary.
2. Insert the battery (7) in the char-
ging compartment of the battery
charger (8). It will audibly snap
in.
3. Plug the battery charger (8) into
a mains outlet. The charging
indicator lights up:
green LED flashes, red LED
lights up: Battery charging
green LED lights up:
Battery is charged
4. When the battery is fully rechar-
ged unplug the battery charger
(8) from the mains.
5. Press the release button (7b) on
the battery (7) and pull the bat-
tery out of the battery charger
(8).

Used batteries

• If a fully recharged battery lasts for
considerably shorter operating times,
the battery is used up and needs to be
replaced. Only use an OEM battery
pack replacement available from our
Customer Service.
• Always take heed of the applicable
safety instructions as well as the envi-
ronmental protection regulations and
information (see "Waste Disposal and
Environmental Protection").

Working with the Lawnmower

Regular mowing encourages increased
foliation of the grass and kills off weeds at
the same time. Therefore, not only does
each mowing increase the density of the
lawn, it also produces an evenly resilient
lawn.
The first cut is to be made in around April,
at a growth height of 70 – 80 mm. In the
main vegetation period, the lawn is to be
mowed at least once a week.
• Run the equipment at a walking pace,
in tracks that are as even as possi-
ble. For gap-free mowing, the tracks
should always overlap by a few cen-
timetres.
• Adjust the cut height so the equipment
is not overloaded. Otherwise, the mo-
tor may be damaged.
• On slopes, always work across the
slope. Take particular care when go-
ing backwards and pulling the equip-
ment.
• Clean the equipment after each
use, as described in the chapter on

"Cleaning, Maintenance and Storage".

Switch off the equipment after
work and in order to transport
it, disconnect the plug and wait
until the blade stops. There is a
risk of injury.
Cleaning, Maintenance
and Storage
Have work that is not described
in these instructions carried out
by a customer service centre
that we have authorised. Use
only original parts.
GB
41