Install Curved Handle; Installing The Grass Box; Initial Operation; Operation - Grizzly ARM 4041 Lion Set Originalbetriebsanleitung

GB
2. Attach the screws with washers
to the desired slot in the
housing (11). You can select
from 3 different height levels.
Release the lower wing nuts (5)
and attach the lower bar to the
device.

Install curved handle

1. Fasten the bow-type handle (1)
C
with the enclosed screws, the
washers and the upper wing
nuts (2) to the right and left of
the lower bar (4).
2. Clipping in the cable holders:
Clip the cable holders (3) onto
the lower bar to fixate the ma-
chine cable (16)
Upon releasing the wing nuts,
you can fold the bow-type
handle downwards to store the
device.

Installing the grass box

Now just stretch the rubber lips
D
of the collection net over the
bars of the grass collection bas-
ket (14)
Attention: Do not operate the ap-
pliance until the collision guard
and grass box are fully installed.
Risk of injury!

Initial Operation

Before operating the machine,
you must
- install the upper and lower upper handles:
- install the collection bag
38
Caution! Risk of injury! During
the assembly or disassembly of
the collection bag, the engine
must be turned off and all mo-
ving parts must have come to a
standstill. Remove the battery
from the device before carrying
out any work.

Operation

Caution! Risk of injury! Always
wear appropriate protective
equipment and work gloves
while working with the appli-
ance. Prior to each use, ensure
that the appliance is working
correctly. Ensure that the coll-
ection bag is installed correctly
and the device has been moun-
ted properly. Do not use the
device if a switch is damaged.
Personal protective equipment
and a fully functional appliance
reduce the risk of injuries and
accidents.
The mower must only be set
when the motor is switched off
and the blades are shut-down.
Switch of the device, pull the igniti-
on key (11) and wait for the blades
to come to a stop. There is a risk of
personal injury.
Mounting/removing the grass
box
Prior to using the collection box,
the mulch kit (20) must be remo-
ved.