Grizzly ARM 4041 Lion Set Originalbetriebsanleitung Seite 32

GB
eyes, additionally seek medical
help. Liquid ejected from the
battery may cause irritation or
burns.
6) SERVICE
• Have your power tool ser-
viced by a qualified repair
person using only identical
replacement parts. This will
ensure that the safety of the
power tool is maintained.
7) SPECIAL SAFETY DIREC-
TIONS FOR BATTERY-OP-
ERATED TOOLS
a) Ensure that the device is
switched off before inserting
the battery. Inserting a battery
into a power tool that is switched
on may result in accidents.
b) Recharge the batteries indoors
only because the battery
charger is designed for indoor
use only.
c) To reduce the electric shock
hazard, unplug the battery
charger from the mains before
cleaning the charger.
d) Do not subject the battery to
strong sunlight over long pe-
riods and do not leave it on a
heater. Heat damages the bat-
tery and there is a risk of explo-
sion.
e) Allow a hot battery to cool be-
fore charging.
f) Do not open up the battery and
avoid mechanical damage to
the battery. Risk of short circuit
and fumes may be emitted that ir-
ritate the respiratory tract. Ensure
32
fresh air and seek medical assis-
tance in the event of discomfort.
g) Do not use non-rechargeable
batteries!
8) CORRECT HANDLING OF THE
BATTERY CHARGER
• This appliance can be used by
children aged from 8 years and
above and persons with reduced
physical, sensory or mental ca-
pabilities or lack of experience
and knowledge if they have been
given supervision or instruction
concerning use of the appliance
in a safe way and understand
the hazards involved. Children
shall not play with the appliance.
Cleaning and user maintenance
shall not be made by children
without supervision.
• To charge the battery, use only
the charger supplied.
Risk of fire and explosion. This
ensures that the safety of the de-
vice is maintained.
Before each use, check the
•
charger, cable and plug and
have them repaired by quali-
fied professionals and only
with original parts. Do not use
a defective charger and do not
open it up yourself. This ensures
that the safety of the device is
maintained.
• Connect the charger only to a
100 - 240 V socket. Ensure that
the mains voltage matches the
specifications on the charger
rating plate. Risk of electric
shock.
• Disconnect the charger from
the mains before closing or