Rear Panel - Yamaha DG60-112 Bedienungsanleitung

Rear Panel

Before making any connections, make sure that the power on the DG60-112
and any external devices is switched OFF.
!1
Channel A/B selection
!1 Foot Switch (FOOT SW)
The following functions can be switched with an optional foot switch
(Yamaha FS1, etc.) connected to these jacks.
• Channel Select (CH SELECT)
You can easily switch between Channels A and B in the same manner
as the Channel Select Switch e on the front panel.
Step on the foot switch to switch between Channels A/B.
* When the foot switch is used, the Channel Select Switch e on the front
panel is inactive.
• Reverb (REVERB)
You can switch the Reverb ON/OFF.
Stepping on the foot switch switches the Reverb ON/OFF.
When the Reverb is switched OFF, no reverb will be produced.
!2 Speaker Mute Switch (SP MUTE)
Press the switch to mute output from the speaker.
Insert a thin object inside the hole to press the switch.
Use this switch in conjunction with the headphones or Line Out when
you don't want sound produced by the DG60-112's speaker.
* When speaker output is muted, output to the EFFECT SEND jack !5 will
be muted as well.
!3 Line Out/Head Phone Jack (LINE OUT/PHONES)
Use this jack to connect directly to a mixer's line jack or use a pair of
headphones.
The line signal from this jack passes through a *speaker simulator.
!3
!2
Reverb on/off
P. A. Mixer or Recording Device
!5 !6
!4
OUT
Headphones
Effect Unit
!4 Effect Send/Return Level Switch (0dB/-20dB)
The output level of the Send Jack !5 and the input level of the Return
Jack !6 can be set to –20dB or 0dB.
!5 Effect Send Jack (EFFECT SEND)
Connect an external effector's input jack to this jack.
* When speaker output is muted, output to the EFFECT SEND jack !5 will
be muted as well.
!6 Effect Return Jack (RETURN)
Connect an external effector's output jack to this jack.
!7 Blend Knob (BLEND)
Use this knob to control the amount of signal that is received from the
effect return and added to the DG60-112's amp signal.
Rotate the knob toward the EFFECT side to add more effect to the tone.
Rotate the knob toward the DRY side for tone without effect.
* What is a Speaker Simulator?
The speaker simulator adds the live nuance of a speaker to the
line signal.
When you connect the DG60-112 directly to a mixer or MTR the
speaker simulator will add the acoustic characteristics of a speaker,
as heard through a microphone, to the tone.
The Panel Controls
!7
IN
7