Precautions; Specifications - Yamaha DG60-112 Bedienungsanleitung

Precautions

Avoid using your amplifier in the following locations to prevent
possible damage:
• In direct sunlight or next to heating equipment.
• Extremely cold or hot locations.
• Locations exposed to high humidity or excessive dust.
• Locations subject to strong shocks or vibration.
Before making any connections, make sure that the power on the
amplifier and any external devices is switched OFF.
To protect the speaker from possible damage, always set the
MASTER knob to "0" before switching the power ON/OFF.
When connecting a speaker to this unit make sure to turn OFF
the power first.
Do not apply excessive force to the switches and controls.
Your Yamaha guitar amplifier is a precision musical instrument.
Handle it with care and avoid dropping or bumping it.

Specifications

Digital Section
Complete Digital Signal Processing
Amplification Type : Internal 8 Channel Preset
Digital Reverb (SPRING)
Speaker Simulator (LINE OUT)
Analog Section
60W Solid State Power Amp
30 cm Speaker (EMINENCE) x 1
Controller/Switch
Front Panel : GAIN, MASTER, TREBLE, HIGH MID, LOW MID,
BASS, PRESENCE, REVERB, AMP select switch, for each
channel (A/B), Channel select switch (A/B)
Rear Panel : EFFECT BLEND, SP MUTE switch, for each
channel (A/B), EFFECT SEND/RETURN level switch
Indicator
Peak Level Display LED (Red)
Connection Jacks
INPUT HIGH/LOW, EFFECT SEND/RETURN, LINE OUT/
PHONES, FOOT SW (CH SELECT, REVERB)
: All Standard Phone Mono Jack
Operating temperatures will rise during use. Make sure the
amplifier is used in a well-ventilated area. The DG60-112 should
be placed in a position were there is at least 30cm (12") clear-
ance from the wall on the sides, top and back of the amplifier.
For safety, always remove the power plug from the AC wall
outlet if there is any danger of lightning striking in your area.
Keep the amplifier away from neon signs or fluorescent lighting
to prevent noise pickup.
To prevent damage and possibly electrical shock, never open the
case and tamper with the internal circuitry.
Never use benzene, thinner or other volatile liquids for cleaning,
as these chemicals may cause damage or discoloration to the
finish. Always use a dry, soft cloth to wipe off dust and dirt.
A/D Converter
D/A Converter
Sampling Frequency
Input Level/Impedance
INPUT HIGH: –20dBm (THRU)/1MΩ
INPUT LOW: –10dBm (THRU)/1MΩ
EFFECT RETURN: 0dBm/120kΩ
Output Level/Impedance
SPEAKER: 60W RMS/8Ω
LINE OUT: +2dBm/47Ω
EFFECT SEND: –2dBm/1kΩ
Power Requirements
U.S. and Canadian models : 120V, 60Hz
General model : 230V, 50Hz
Power Consumption
70W
Dimensions (W x H x D)
540 x 504 x 276 mm (21.3" x 19.8" x 10.9")
Weight
18.0 kg (39 lbs 11 oz)
* Specifications and external appearance are subject to change without notice.
20 bit + 3 bit floating
20 bit
48 kHz
5