Call Screening - switel CCT 507 Bedienungsanleitung

Answering Machine
Setting the number of rings (answering delay)
You can select from 2 to 9 rings and the Tollsaver (tS) setting for pre−
remote access free of charge. The toll−saving, pre−remote access fea-
ture can be used to check whether new messages have been received
on your answering machine from a distant telephone.
S
S
3 sec.
2 times
y
s
For further information on remote access, refer to . Page 72.

Call screening

Call screening of incoming calls is always activated and you hear the
caller via the loudspeaker.
Taking a call being recorded
It is possible to take a call even if the answering machine has already
begun to take it. Recording of the message is stopped in this case.
è
Selecting the answering mode
The answering machine is provided with two, pre−recorded outgoing
messages (OGM 1 and OGM 2). After OGM 1 has been played, the cal-
ler can leave a message. OGM 2 is purely an answer only announce-
ment after which no message can be left. Both outgoing messages can
be replaced by ones of your own. When the answering machine's me-
mory is full, OGM 2 is automatically played.
s
70
If new message have been recorded on your answering machine,
your call is taken after 2 rings.
If no new messages have been recorded, the call is taken after
5 rings. End the call before the 5th ring. This means that no
charges ensue.


z 
or ,
Ò
or
Activate programming mode
Open the menu
Select the setting and confirm it
Close the menu
Take the call
50
Change the outgoing message