Safety Information - Sonus Faber Venere S Bedienungsanleitung

SAFETY INFORMATION

Install the speakers in order to achieve the best possible stability. If it's the case, adjust points/feet supports. Avoid placing heavy
objects on the speaker as they can compromise its stability.
In case the speaker is placed on a surface other than the suggested stands (ex. shelves, bookcases, TV supports, etc.) or
directly the floor, firstly check that it can support the weight of the speaker(s). Also check that there is enough friction between
the speaker and the surface in order to avoid any movement caused through vibrations whilst in use. Where needed rubber
adhesive feet can be purchased from all good hardware stores.
Do not put any objects containing water or other liquid/liquefiable substance on the speaker system.
Follow the connection diagram suggested in the instructions manual. Remember that the parallel connection of two or more
speakers can damage your amplifier. If in doubt, contact your dealer.
Whilst the audio system is operative at high volumes avoid staying in close proximity to the speaker system. This can cause
permanent damage to your hearing! Children should maintain a safe distance from the speaker system of at least 50cm.
The speakers produce an electromagnetic field which is harmless to humans and pets, but they can cause disturbances in the
correct functioning of electronic equipment such as monitors or cathode tube TVs when placed in close proximity. If this occurs,
simply and slowly distance one from the other. As a further precaution, it is not advisable to place credit cards or similar
magnetically read objects on top of the speaker system.
The technology behind the functioning of the speakers is based on the principles of electromagnetism, and thus the user
should avoid operating equipment that generates strong electromagnetic fields as these could affect the correct functioning of
the speaker. Avoid placing transmitting devices such as mobile phones, cordless phones, intercom systems etc. on top of the
speaker systems.
Do not directly connect to a constant voltage (100V, 70.7V or similar) sound distribution system. This could have as a
consequence a serious system's overload with probable damages to the loudspeaker system and/or the amplifier unit.
Keep amplifier-speaker connection and power (mains) cables separate. Mains cables carry an alternating voltage at a frequency
of 50Hz (60Hz in Japan and the USA) and an intensity that can be high, and thus produce an electromagnetic field even at
audio frequency around them. In the case of coupling of these two types of cables an annoying hum noise will be perceived
through the speakers. If this should occur, do provide an adequate distance between the cables.
Be very careful during the assembly and disassembly of the rubber string grille, if present. Check that the first metal string holder
is properly inserted before tightening the strings to secure the second one.
The speaker cable terminals accept banana plugs. Remove the red and black plastic caps only if you intend to implement this
type of connection and ensure that the other end of the cable is connected to the power output terminals of your amplifier. This
protection is aimed at avoiding accidental connection to unprotected electrical outlets.