Teaching-In Devices To The Ccu3 - HomeMatic CCU3 Montage- Und Bedienungsanleitung

Start-up
7.4

Teaching-in devices to the CCU3

Please read this entire section before starting
the teach-in procedure.
Your Homematic and Homematic IP device can be
conveniently controlled and configured or used in Central
Control Unit programs using a software-based method.
Therefore, they must be integrated into the system via the
WebUI. To do this, please proceed as follows:
• Start the WebUI user interface in the web browser
of your PC.
• Click the "Teach-in devices" button on the right-
hand side of the screen.
• To activate teach-in mode of the CCU3, click
on the desired teach-in window (e.g. "Teach-in
HmIP device"). The teach-in mode of the Central
Control Unit will be activated. An information box
shows how much teach-in time remains.
44
• Activate the teach-in mode of the device, that you
want to teach in. Please refer to the user manuals
of the corresponding devices for further informa-
tion.
• Please wait until teach-in is completed.
• If teaching-in was successful, the LED lights up
green. If the LED lights up red, please try again.
• After a short time, the newly connected device
appears in the inbox of your WebUI.
Newly connected devices and the corresponding chan-
nels are ready for operation and configuration only after
they have been configured in the inbox. You will find fur-
ther information in the Homematic WebUI Manual, avail-
able for download at www.eQ-3.com.
Start-up
45