Connection With The Mains; Operation; Stand Alone Mode - EuroLite LED SLS-145 TCL SMD 5050 Floor Bedienungsanleitung

Choose the device which is to control the effects. This device then works as master device and controls all
other slave devices, which are to be connected to the master device via a DMX-cable. Connect the OUT jack
with the IN plug of the next device.
Please see further instructions under Operation.

Connection with the mains

Connect the device to the mains with the enclosed power supply cable.
The occupation of the connection-cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Lighting effects must not be connected to dimming-packs.

OPERATION

After you connected the EUROLITE LED SLS-145 to the mains, the device starts running.
The LED display lights up and you can now choose the desired settings via the buttons MODE, ENTER, UP
and DOWN.
The device has two operating modes. It can be operated in Stand Alone or in DMX-controlled mode.
STANDALONE-MODE
-
Setting Solid Colors
-
Auto Mode
-
Master/Slave Mode
-
DMX MODE
-

Stand Alone mode

Setting solid colors
Press the MODE button until the LED display shows "C---", then press the ENTER button to confirm.
The desired color can be selected via the UP or DOWN buttons, then press the ENTER button again to
confirm.
Mode:
C
International
L
N
Value:
C 1
C 2
C 3
C 4
C 5
C 6
C 7
Function:
Red
Green
Blue
Cyan
Magenta
Yellow
White
20/23 00066546.DOC, Version 1.2