Dmx-Mode - EuroLite LED SLS-145 TCL SMD 5050 Floor Bedienungsanleitung

Auto Mode
In Auto Mode the internal program is called up automatically in a continuous loop.
Press the MODE button until the LED display shows "P---", then press the ENTER button to confirm
The desired program can be selected via the UP or DOWN buttons, then press the ENTER button again to
confirm.
Mode:
P
After choosing the program, you can adjust the desired speed. Press the ENTER button until the display
shows S___. Press the ENTER button and select the desired speed (S000 – S100, increasing speed) via the
UP or DOWN buttons. Press ENTER to confirm.
You can do without a controller as the device features a built-in microphone, which provides automatic sound
control. You can adjust the sensitivity with the rotary-control on the rear panel.
Master/Slave Mode
The master/slave operation enables that several devices can be synchronized and controlled by one master
device.
On the rear panel of the device you can find an XLR jack and an XLR plug, which can be used for
connecting several devices.
Choose the device which is to control the effects. This device then works as master device and controls all
other slave devices, which are to be connected to the master device via a DMX-cable. Connect the OUT jack
with the IN plug of the next device.
Set the Master device to one of the stand alone modes ("C---" or "P---") and set each Slave device to the
same DMX address "d 1".

DMX-Mode

The device has different DMX channel modes. The Control Board allows you to assign the DMX channel
mode and the DMX fixture address, which is defined as the first channel from which the device will respond
to the controller.
Addressing
Press the MODE button until the display shows 3CH or 5CH. Press the ENTER button. The display shows
"d—". You can now set the desired address via the UP or DOWN buttons. Press ENTER to confirm.
Please, be sure that you don't have any overlapping channels in order to control each device correctly and
independently from any other fixture on the DMX-chain. If several devices are addressed similarly, they will
work synchronically.
Controlling:
After having addressed the device, you may now start operating it via your lighting controller.
Please see the following DMX protocol graphics for the respective channel values.
Value:
P 1
P 2
P 3
P 4
P 5
P 6
Function:
Endless loop in 7 colors
Endless loop in 7 colors
Endless loop in 3 colors
Endless loop in 3 colors
Endless loop in 7 colors,
via sound control
Endless loop in 3 colors,
via sound control
21/23 00066546.DOC, Version 1.2