What To Do If - Becker Centronic SunWindControl SWC442-II Montage- Und Betriebsanleitung

Problem
Drive is not functioning.
Automatic drive commands are not
executed.
System does not extend automatic-
ally when slide switch is set to " ".
System does not extend automatic-
ally manually slide switch is set to " "
or " ".
The lighting equipment goes on
when the travel buttons are pressed.
28 - en

What to do if...?

Insert a new battery.
Insert the battery correctly.
Reduce the distance to the receiver.
Transmitter is not programmed in the
receiver.
Program transmitter.
Set the slide switch to " ".
The automatic sun protection func-
tion was interrupted by a manual
drive command. Move the slide
switch from " " to " " and back to
" ".
Adjust sun threshold value.
Wait for the wind to die down.
Wind threshold value exceeded. Wait
for the wind to die down.
Assignment of transmitter and re-
ceiver is incorrect. Repeat the pro-
gramming of the light function.
Remedy