Test Mode; Factory Default Settings - Becker Centronic SunWindControl SWC442-II Montage- Und Betriebsanleitung

TEST mode

The TEST mode is activated by adjusting the threshold value. It automatically
ends after about 15 minutes. In TEST mode, the time for which the wind is
monitored is shortened.
Light control button
The light control button allows you to switch the lighting equipment on or off,
and to dim it.
If the light control button is held down for less than about 0.5 seconds, the
lighting equipment will switch ON or OFF.
If the light control button is held down for longer than 0.5 seconds, the lighting
equipment dims according to the command sequence of maximum value,
minimum value, etc.
Sun threshold value
Wind threshold value

Factory default settings

Medium setting (about 25 kLux)
Left stop (about 2 m/s)
23 - en