Wind Threshold Regulator (In Connection With A Suitable Sensor From The Controller Manufacturer); Sun Threshold Regulator (In Connection With A Suitable Sensor From The Controller Manufacturer) - Becker Centronic SunWindControl SWC442-II Montage- Und Betriebsanleitung

Wind threshold regulator (in connection with a suitable
sensor from the controller manufacturer)
You set the wind threshold value with this regulator (between about 2 m/s and
22 m/s).
The wind threshold value can be adjusted in 11 steps. When slowly turning the
regulator, the tubular drive clicks to indicate the setting changes.
- Left stop
+ Right stop
Changes made to the threshold value are transferred immediately.
When setting the threshold, ensure that no button is
pressed. When the wind speed exceeds the set wind
threshold value, the sun protection system retracts and re-
mains closed. The sun protection system can only be exten-
ded again after the wind speed has remained below the
threshold value for approx. 15 minutes.
Sun threshold regulator (in connection with a suitable
sensor from the controller manufacturer)
You set the sun threshold value with this regulator (between about 2 kLux and
100 kLux).
The sun threshold value can be adjusted in 15 steps. When slowly turning the
regulator, the tubular drive clicks to indicate the setting changes.
- Left stop
+ Right stop
Changes made to the threshold value are transferred immediately.
When setting the threshold, ensure that no button is
pressed. If the set sun threshold value is exceeded, the sun
protection system extends after a delay of up to 5 minutes.
The sun protection system automatically retracts after the
sunshine level has been continuously below the threshold
value for about 15 minutes.
22 - en
Stage 1, retract at low wind
Stage 11, retract at very high wind
Stage 1, retract at low sunshine level
Stage 15, retract at full sunshine