Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
7. OPERATION
7.1 Playing a record
1
Remove the protective cover of the stylus.
2
Switch on the turntable with the power switch. The target light lights up.
3
To select the speed, press the corresponding button:
• for 33⅓ RPM the left button (basic setting)
• for 45 RPM the right button
• for 78 RPM both buttons simultaneously
To indicate the selected speed, the corresponding LED above the buttons lights up.
4
Put on the record. For 7" records, use the adapter.
5
Open the locking lever for the tone arm to the right. To lift the tone arm, place the lever for the tone arm
lift to the rear position.
6
Seize the handle of the tone arm, and place the stylus above the beginning or the desired spot on the
record. Place the lever for the tone arm lift to the front position. The tone arm is slowly lowered onto the
record.
7
Press the start/pause button
stopped at any place and be restarted with the start/pause button
8
To stop the motor press the button MOTOR OFF (red control LED flashes).
9
To stop the playing, lift the tone arm with the tone arm lift and put it back onto the tone arm support by
hand. Stop the turntable platter with the start/pause button
10 After use of the turntable, secure the tone arm with the locking lever and switch off the unit with the
power switch.
7.2 Adjusting the speed
The speed of the turntable and thus the pitch of a title can be increased or reduced by up to 50 % with the
pitch control. With the control in mid-position (control locks into place) and as a basic setting after switching
on, the turntable plays at the exact, quartz-controlled standard speed (0 % speed deviation). As an indication
the blue LED above the button QUARTZ and next to the pitch control lights up.
1
Press the button QUARTZ, to activate the pitch control (blue control LEDs off).
2
As a basic setting after switching on, the adjusting range for the speed is ±10 % (red control LED "10"
lights up). To switch to another adjusting range press the button PITCH SELECT. Each actuation of the
button switches the unit between 10 %, 20 % and 50 % (the corresponding red control LED lights).
3
Change the speed with the pitch control. Slide it up to decrease the pitch, slide it down to increase the
pitch.
4
To switch back to the standard speed, press the button QUARTZ again (LEDs for crystal control light up
again).
7.3 Switching to reverse run
With the button REVERSE you can switch over the sense of rotation. For this purpose shortly press the
button. With the reverse run switched on, the red control LED lights up.
. The turntable platter starts to rotate. While playing, the record can be
25/28
.
.
00042136.DOC, Version 1.0
Werbung
Inhaltsverzeichnis
