Connections; Operation; Playing A Record - Omnitronic BD-1320 Bedienungsanleitung

6. CONNECTIONS

Prior to connecting or changing existing connections switch off the turntable.
1 Connect the analog audio output of the turntable with the supplied RCA cable to the corresponding input
jacks at the amplifier or mixer. Make sure that the right/left occupation (plug color red/white) is the same
at both units. Connect the ground connection of the cable to the ground terminal of the amplifer or mixer.
2 Connect the mains plug to a socket (230 V AC, 50 Hz ~). The unit can also be operated with 115 V AC,
60 Hz ~. For this purpose, set the voltage selector switch underneath the platter to the upper position
110-120 V (Fig. 7).
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation. The device
must only be connected with an electric installation carried out in compliance with the IEC-standards. The
electric installation must be equipped with a Residual Current Device (RCD) with a maximum fault current of
30 mA.
Fig
. 7: Voltage selection

7. OPERATION

7.1 Playing a record

1 Remove the protective cover of the stylus.
2 Switch on the turntable with the power switch. The stroboscope lamp lights up.
3 To select the speed, press the corresponding button (control LED lights):
• for 33⅓ RPM the left button "33"
• for 45 RPM the right button "45"
4 Put on the record. For 7" records, use the adapter.
5 Open the locking lever for the tone arm to the right. To lift the tone arm, place the lever for the tone arm
lift to the rear position.
6 Seize the handle of the tone arm, and place the stylus above the beginning or the desired spot on the
record. Place the lever for the tone arm lift to the front position. The tone arm is slowly lowered onto the
record.
20/22 00042383.DOC, Version 1.0