Assembly And Basic Adjustments - Omnitronic DD-4750 Bedienungsanleitung

22 Analog audio output (stereo RCA)
For connection to a line input or phono input, e.g. of an
amplifier or mixer.
23 Selector switch PHONO/LINE
Switches the audio level of the analog audio output
• PHONO for connection to a phono input
• LINE for connection to a line input

5. ASSEMBLY AND BASIC ADJUSTMENTS

The headshell, the turntable platter and the counterweight for the tone arm are separately packed to prevent
damage to the turntable during transportation. After unpacking, the parts can be easily assembled. The
packing material should be kept for transportation purposes.
5.1 Mounting the turntable platter
1 Set up the turntable on a plane, stable ground and place the turntable platter on the axle of the turntable.
2 Place the supplied slipmat on the turntable platter.
5.2 Mounting the headshell and the counterweight for the tone arm
1 Take the headshell out of one of the two lateral polystyrene wrappings, place it onto the front end of the
tone arm, and secure it with the locking nut (Fig. 1).
2 Take the counterweight out of one of the two lateral polystyrene wrappings and place it on the rear end
of the tone arm until it locks into the place. The counterweight is then used for precise adjustment of the
stylus pressure on the record (Fig. 2).
Fig. 1: Mounting the headshell
24 USB connection for connecting a computer
25 AC connection
Plug in the supplied power cable here.
26 Power on/off
27 Voltage selector switch
Fig. 2: Mounting the counterweight
21/28 00042136.DOC, Version 1.0