Service And Maintenance - Storch Variotool Bedienungsanleitung

SERVICE and MAINTENANCE

Take care not to expose this tool to the rain.
Cleaning
Avoid using solvents when cleaning plastic parts. Most plastic parts are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use clean cloths to remove dirt, carbon dust, etc.
Lubrication
All the gears in this tool are lubricated with a sufficient amount of high grade lubricant for the life of the unit under nor-
mal operating conditions, therefore no further lubrication if required.
Electrical products must not be thrown out with domestic waste. Recycle them at the special disposal centers provided
for the purpose. Contact your local authorities or stockiest for advice on recycling.
Li-ion:
Do not dispose of battery packs/batteries as household waste, and do not throw onto fires or into water. Battery packs/
batteries should be collected, recycled or disposed of in an environmental-friendly manner.
WARNING:
To avoid serious bodily injury remove the battery pack from the tool before conducting any cleaning and maintenance
work.
WARNING:
Only use original spare parts for maintenance work. The use of other parts can be dangerous or result in damage to pro-
perty.
WARNING:
We do not advise using compressed air to clean the Variotool. If compressed air is the only way you can clean the
device, always wear protective goggles or safety goggles with side protection. If a large amount of dust occurs, additio-
nally wear a dust mask.
7. Warranty
Warranty conditions
A warranty period of 12 months from the date of purchase/date of invoice applies to our tools for commercial custo-
mers. If we have granted an extended warranty period, this said period will be noted separately in the operating manu-
al for the equipment in question.
Claims
If you wish to claim under our warranty or guarantee, please return the complete equipment and your invoice to our
logistics centre in Berka, postage paid, or send it to one of our authorised service centres.
Your rights under our warranty or guarantee
Claims can only be accepted for material defects or manufacturing errors, and only assuming intended use of the appli-
ance. Wear parts (e.g. tools, sandpaper) are not covered by warranty. Fitting third party parts, improper use and sto-
rage, and obvious failure to observe the operating instructions will void your warranty.
Repairs
All repairs must be conducted on our premises or by an authorised STORCH service centre.
Original instruction 90