Switching Off The Device; Additional Information - Storch 65 57 20 Bedienungsanleitung

Setting the air flow rate
The air flow rate can be adjusted in five stages via the control panel (8). The
settings you have selected can be read in the LCD display (6).

Switching off the device

Switch off the device by setting the handle switch to position "0". The fan now
switches off completely and the heating element is no longer heated. Place
the device vertically on the supporting surfaces intended for this purpose and
allow it to cool down completely before storing or transporting it again.
Tip: To speed up the cooling process, switch the device to stage 1 and leave it
run for a few minutes at 50 °C and 500 l/min. This will enable the device to
cool down much quicker.
Memory function
The temperature and air flow rate last selected are retained after switching off
the device. The next time it is switched on the hot-air stripper gun will revert
to the last selected setting.
Cleaning
Make sure the air intake openings (4) on the housing are kept open at all
times and clean the cool device regularly with a soft cloth.

Additional information

Some smoke may be produced when you use the device for the first time. This
is normal and will stop after a short while.
Always determine the correct operating temperature for the respective acti-
vity. First check the properties of the material to be processed at the lowest
temperature setting and then gradually increase the amount of air flow in an
inconspicuous area.
The temperature will drop if the distance between the air outlet / nozzle and
the material being processed decreases.
The temperature is dependent on the material you are working on.
Original instruction 48