Commissioning - Storch 65 57 20 Bedienungsanleitung

Do not obstruct the air intake or hot air outlet. Clean the air intake at regular
intervals by using a soft brush.
Never use additional nozzles that change the cross-section of the delivery
outlet, unless they have been approved for use by the manufacturer; the heat
backlog this causes will damage the device.
The device has been designed in such a way that it generates a concentrated
jet of hot air without any additional nozzles.
Never direct the jet of hot air at anyone and do not look directly into nozzle
opening on the exhaust pipe.
Never leave the device switched on and unattended!
The device should only be switched on and off by using the power switch;
never switch it on or off by inserting the mains plug into, or pulling it from, the
socket!
If the motor fails, switch off the device immediately to avoid heat building up
in the device.
Caution: Risk of burning from the metal exhaust pipe! Do not touch!
Keep the hot air gun away from children!
Do not use the device as a hairdryer (risk of burning)!
After use, place the device on the supporting surfaces intended for this pur-
pose (see device description) on a sturdy, non-flammable surface and allow the
device to cool down completely before placing it in the carrying case or storing
it elsewhere.

Commissioning

Before commissioning the device, please check to ensure the mains voltage
corresponds with the specifications on its rating plate. Before use, make sure
the housing and cable are undamaged. Check the functionality of the device
prior to each use. In the event of a defect, please contact a STORCH work-
shop immediately.
Original instruction 46