Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
The hot-air stripper gun has been designed in such a way that it can be ope-
rated easily, and without additional parts, as follows:
1.
as a handheld device
2. as a desktop unit in vertical operation (free-standing unit such as a Bunsen
burner)
Switching on the device
The device is set to continuous operation by pressing the switch (9) in the
handle. When used in connection with the control panel (7 and 8), the two
switching stages in the handle result in the following operating modes:
Switch setting in
the handle (9)
1
2
Please observe the following sections "Setting the temperature" and "Setting
the air flow rate".
Setting the temperature
The temperature can be increased
and decreased in intervals of 10 °C
via the control panel (7). To increase
the temperature press the left-hand
button (+); to decrease the tempera-
ture press the right-hand button (-).
Either tap the buttons briefly or press
and hold the buttons until the desired
temperature setting is reached.
When doing this please note the
maximum
temperature,
depends on the two respective stages
of the switch. The maximum tem-
perature is only possible in swit-
ching stage 2. If switching stage 1
is selected, the maximum tempera-
ture is 50 °C. The setting you have
selected can be read in the LCD dis-
play (6).
Air flow rate (8)
250 - 500 l / min.
250 - 500 l / min.
which
47
Temperature (7)
max. 50° C
50° C to 650° C
Attention
Do not drop the device - the ceramic
heating element that is located inside
the device is particularly sensitive to
shock and impact.
Original instruction
Werbung
Kapitel
Inhaltsverzeichnis
