Cembre rhu520 Bedienungsanleitung Seite 3

39
33
34
35
FIG. 2 DIES - MATRICES - PRESSEINSÄTZE - MATRICES - MATRICI
FIG. 3
DIE INSERTION
INSERTION DES MATRICES
POSITIONIERUNG DER
PRESSEINSÄTZE
INSERCIÓN DE LAS MATRICES
INSERIMENTO MATRICI
01
36
37
38
32
04
03
17
HYDRAULIC PRESSHEAD
RHU520
1. GENERAL CHARACTERISTICS
– Application range: suitable for installing compression connectors for conductors
up to ........................................................1200 mm
– Crimping force: ......................................................................520 kN
– Max. operating pressure: ......................................................700 bar
– Dimensions: length ................................................................306 mm
width ..................................................................200 mm
– Weight (without dies): .............................................................18 kg
2. INSTRUCTIONS FOR USE
2.1) Setting
The head is equipped with a "self-lock" quick male coupler and can be connected to a
Cembre hydraulic pump developing 700 bar pressure.
The adapter AU520-130C is available as an optional extra enabling the head to utilise the
semi-circular slotted dies common to most 130 kN tools.
2.2) Die insertion
(Ref. to Fig. 2 and 3)
Dedicated dies
– Select the appropriate die set for the connector to be crimped.
– Extract the die locating pin (04) from the head.
– First, insert the lower die (38) into the fork (01) and check that the stud (32) situated be
low the die is inserted in the ram seat (03) then rotate die at 90° and check it is locked
in operating position.
– Then fi t the upper die (37) into the head and insert the die locating pin (04).
– To remove the dies from the head, extract the die locating pin (04) and slide out the
dies.
Semi-circular dies
– Select the appropriate die set for the connector to be crimped.
– Extract the die locating pin (04) from the head.
– Insert the lower part (35) of adapter AU520-130C into the fork (01) and check that the
stud (32) situated below the die is inserted in the ram seat (03) then rotate adapter at
90° and check it is locked in operating position.
2
ENGLISH
2 (2000 MCM)
(58.4 sh ton)
(10,000 psi)
(12 in.)
(7.9 in.)
(39.6 lbs)