Manual Station Scan; Manual Station Tuning - Silvercrest SSR 10 A1 Bedienungsanleitung

 Press the "MODE" button (3) for approx. 2 seconds to start the
automatic station scan. The automatic station scan always
starts at the lowest frequency (87.5MHz).
 The scan radio now searches the entire frequency range for
stations with strong signals. On the display (1), "SCAN" (14)
flashes.
 The first 10 stations found are stored directly in the presets 01
to 10 and saved.
Please note that already occupied presets are
overwritten.

Manual station scan

 Switch on the scan radio with the "On/Standby" button (6).
 Press the "-" button (2) or "+" button (4) for approx. 2 seconds
to start the manual station scan downwards or upwards. As
soon as the device finds a station with a strong signal, the scan
stops and the station is played.
 If you want to switch to another station, press the "-" button (2)
or "+" button (4) again to restart the manual station scan
downwards or upwards. The device searches for the next
station with a strong signal.

Manual station tuning

As an alternative to the automatic or manual station scan, you
can also tune in stations manually. This enables you to find
stations with weaker signals also. Proceed as follows:
 Switch on the scan radio with the "On/Standby" button (6).
SilverCrest SSR 10 A1
English -
15