End Of Programming - Key Automation VIPER LED Anleitungen Und Hinweise Zu Installation Und Einsatz

EN
4.18 Setting a second radio channel function
(Default setting: "2")
B
After parameter "A" press "+"
to display "B"
Press "+" or "-" to select the required function:
0= only motor courtesy light active
1= only external courtesy light COM-LED active
2= motor courtesy light + external courtesy light COM-LED active
3= pedestrian function active: partial opening of 1 m
Note: in order to exit the programming and save the parameters push P button for 5 seconds.
4.19 Selection of duration of courtesy light, with activation via second radio channel (only when parameter b not set to 3)
(Default setting: "3")
C
After parameter "b" press "+"
to display "C"
Value
Time not active
On each automation movement command, the courtesy led light on the motor, and external courtesy light COM+LED (if fitted) will
remain lit for 3 minutes.
Note: in order to exit the programming and save the parameters push P button for 5 seconds.

4.20 End of programming

Warning: this final step must be done otherwise information will not be saved.
It is possible to abandon the programming phase and save data in any step on the functions menu from 4.11 to 4.20 in the following mode:
Press "P" in any function from 1
to 9 until the display shows the
set value
28
Press "P"; the display shows
"2" to indicate that the built-in
courtesy light on the motor and
the external light COM-LED
are active
3
Press "P"; the display shows
"3" to indicate that the duration
of the courtesy light set in the
second radio channel is 3 min
0 1 2
1 min 2 min
Press and hold "P" for 5 sec-
onds to save the modifications
made
3 4 5
3 min 5 min 15 min
A beep followed by a sliding "0"
indicates that the programming
procedure has concluded suc-
cessfully
6 7 8
30 min 1 h 8 h
9
12 h