Waste Disposal - Beninca CP.BISON OM Bedienungsanleitung

In the event of malfunctions, by pressing key + or - the status of all inputs (limit switches, control and safety) can be displayed. One
segment of the display is linked to each input. In the event of failure it switches on according to the following scheme.
F1 Protection fuse of transformer
F2 Output protection fuse of accessories and signals
F3
Output protection fuse for motor and blinker
Some messages that are displayed in the event of malfunctions are shown hereunder:
Motor
Err1
Error, PHOT O circuit check
Err4
Error, PHOT C circuit check
Err5
Error, encoder
ENC
Obstacle detection
Amp
If the product must be dismantled, it must be disposed according to regulations in force regarding the differentiated waste disposal
and the recycling of components (metals, plastics, electric cables, etc..). For this operation it is advisable to call your installer or a
specialised company.
18
DIAGNOSTICS
SWO SWC
P.P. PED OPEN
PHOT 0 STOP
PHOT C
DAS
FUSES
ERROR MESAGES
Technical assistance is required.
Check connections, alignment of PHOT O photocell or obstacle present.
Check connections, alignment of PHOT C photocell or obstacle present.
Error to connection or faulty encoder.
An obstacle present is indicated (anti-crash device).

WASTE DISPOSAL

CLOSE