Countdown Function - Silvercrest SWEP 500 A1 Bedienungsanleitung

Countdown function

The countdown function is only available when the radio is switched off.
Set and save countdown
• Press and hold down the
the screen shows 0.00 D. The D blinks.
UP
• Press the
5 countdown times are preset on the memory buttons and you can open
these directly using the corresponding memory button:
M.0/5
Button
M.2/7
Button
M.4/9
Button
MEM
• Press the
MEM
flashes on the screen. Now use the
a memory space; when you press the relevant memory key the time is
saved in this memory space and the time previously stored there
overwritten.
MEMORY SCAN
• When the
countdown mode.
Call up and activate the countdown function
• Press and hold down the
the screen shows 0. 00 D.
• Select the desired, saved countdown time with the aid of the
memory buttons.
SNOOZE
• Press
pauses the countdown.
When the set time has been counted down, an alarm sound plays for one
minute becoming gradually higher in tone and louder.
MEMORY SCAN
• Press the
countdown mode.
MEMORY SCAN
DOWN
or button to set the desired time.
5:00
15:00
25:00
button to save the set time, the memory space indicator
button is pressed again you leave the
MEMORY SCAN
to start the countdown. Pressing the
button to pause the countdown and leave
button for around 2 seconds,
M.1/6
Button
M.3/8
Button
M.0/5
–
button for around 2 seconds,
- 55 -
GB/MT
10:00
20:00
M.4/9
buttons to select
M.0/5
SNOOZE
button again
M.4/9
–