Siemens MP 277 INOX 10 Betriebsanleitung Seite 59

6. Tighten the screws of the clamps with 0.8 Nm.
7. Ensure that the flat gasket is correctly positioned on the front:
MP 277 INOX 10" Touch, MP 377 INOX 15" Touch
Operating Instructions (Compact), 01/2009, A5E02274759-02
The following figure shows the positions of all clamps ①, using the
MP 277 INOX 10" Touch as example.
– The flat gasket can protrude slightly on the device.
– There should be no groove between faceplate and control cabinet in which
contaminants, such as dust or liquids, can accumulate.
Mounting and connecting
2.5 Mounting the HMI device
59