Mounting The Hmi Device - Siemens MP 277 INOX 10 Betriebsanleitung

Mounting and connecting

2.5 Mounting the HMI device

2.5 Mounting the HMI device
Introduction
This section describes how to mount the HMI device in a control panel.
CAUTION
Install the HMI device properly. This will prevent damages to the HMI device and loss of
warranty. Follow the installation instructions.
Procedure
Procedure:
1. Remove all packaging and the protective film of the HMI device.
2. Check the correct fit of the mounting seal. If necessary, correct the position of the seal.
3. Insert the HMI device into the mounting cut-out from the front.
4. Place the clamping frame with the centering bore holes onto the HMI device.
5. Insert the hooks ① of the clamps ② into the recesses ④ of the HMI device.
58
Take the necessary precautions to ensure that the HMI device cannot drop out of the
control panel before it has been secured in place.
Make sure that the flat side of the frame makes contact with the back of the switchboard.
Make sure that the centering points ③ of the clamps are inserted into the corresponding
centering bore holes ⑤ of the clamping frame.
MP 277 INOX 10" Touch, MP 377 INOX 15" Touch
Operating Instructions (Compact), 01/2009, A5E02274759-02