Inhaltsverzeichnis
Werbung
ENGLISH
BATTERY OPERATED HYDRAULIC NUT SPLITTING TOOL
B-TD3241T ; B-TD3241TA
1. GENERAL CHARACTERISTICS
TOOL TYPE:
Application range:
Rated operating pressure bar (psi):
Dimensions LxWxH
mm (inches):
Weight with battery
kg (lbs):
Motor
Volt DC:
Battery
Volt / Ah:
Battery charger supply
Volt / Hz:
Recommended oil:
AGIP ARNICA 32 or SHELL TELLUS TX 32 or equivalent.
Operating speed:
the tool has a twin speed operation and automatically
Safety:
the tool is equipped with a maximum pressure valve.
Operating temperature:
Acoustic Noise (Directive 2006/42/EC, annexe 1, point 1.7.4.2 letter u)
– The weighted continuous acoustic pressure level equivalent
A at the work place L
is equal to .................................................................................75 dB (A)
pA
– The maximum value of the weighted acoustic displacement
pressure C at the work place L
is ..................................................................... < 130 dB (C)
pCPeak
– The acoustic power level emitted by the machine
L
is equal to .............................................................................................................85,3 dB (A)
WA
Risks due to vibration (Directive 2006/42/EC, annexe 1, point 2.2.1.1)
Tests carried out in compliance with the indications contained in UNI ENV 25349 and UNI EN 28662
part 1
Standards, and under operating conditions much more severe than those normally found,
st
certify that the weighted root mean square in frequency of the acceleration the upper limbs
are exposed to for each biodynamic reference axis does not exceed 2.5 m/sec
This hydraulic tool is powered by a 14.4 V battery.
The residual battery capacity level is automatically displayed after every cycle.
B-TD3241T
B-TD3241TA
suitable for splitting fastening bushes, hexagonal
and square nuts as indicated in table 4 page 36.
700 (10,000)
1369 x 94 x 302 (53.9 x 3.7 x 11.9)
7,1 (15.6)
7,4 (16.3)
14.4
14.4 / 3.0 Li-Ion
14.4 / 3.0 Ni-MH
220 - 240 / 50 - 60
120 / 50 - 60
switches from a rapid advancing speed of the ram
to a slower, more powerful cutting speed.
-15°C to +40°C (+5°F to +104°F)
.
2
3
36
Werbung
Inhaltsverzeichnis
