LaserLiner SuperPlane-Laser 3D Pro Bedienungsanleitung Seite 17

SuperPlane-Laser 3D Pro / SuperPlane-Laser 3G Pro
3
Horizontal and vertical levelling
Release the transport restraint, set slide switch (2) to „ON". The horizontal
laser line appears. The laser lines can be switched individually with the
selection button.
LASER
The transport restraint must be released for horizontal and vertical
!
levelling. The laser lines flash when the device is outside the automatic
levelling range of 3.5°. Position the device such that it is within the
levelling range.
4
Slope mode
Do not release the transport restraint, set slide switch (2) to „OFF". Select
the laser with the selector button (9). Sloping planes and tilts can now be
measured. In this mode, the laser lines no longer align automatically. This
is signalised by the laser lines flashing.
LASER
LASER LASER
LASER LASER LASER
17
EN