Folding The Handlebar In And Out (06); Adjusting The Handlebar To The Body Size (07); Setting The Working Depth (08) - AL-KO COMBI-CARE 36.8 E Comfort Betriebsanleitung

GB
6.2

Folding the handlebar in and out (06)

CAUTION!
Danger of crushing
Fingers or other parts of
the body can be crushed
between the loose parts of
the handlebar.
■
Hold the loose parts of
the handlebar tightly.
■
Do not hold any fingers
or other parts of the
body between the loose
parts.
IMPORTANT!
Danger of damaging the
power cable
The motor and mains ca-
bles can be crushed and
damaged between the
loose parts of the handle-
bar.
■
Do not jam the cables
when folding the han-
dlebar in/out.
Folding in the handlebar
1. Release the quick release (06/1) and fold the
top handlebar (06/2) downwards (06/a).
2. Release the quick release on the rotary/snap-
in joints (06/3) until the entire handlebar can
be folded forward into the horizontal position
(06/b).
3. Slightly tighten all quick releases.
Folding out the handlebar
Proceed in reverse order.
38
6.3 Adjusting the handlebar to the body
size (07)
1. Loosen the quick release on the rotary/snap-
in joints (07/1).
2. Adjust the entire handlebar to the desired
height (07/a) at the handle (07/2). The move-
ment is limited by the end stops (07/3) of the
rotary/snap-in joints.
3. Tighten the quick releases (07/1).
6.4 Setting the working depth (08)
The setting of the working depth depends on:
■
Grass condition (well-kept: low working
depth, overgrown: large working depth)
■
Blade wear (new: low working depth, worn:
large working depth)
If the working depth is too large: The appliance
stands still and the motor does not run.
IMPORTANT!
Danger of damage to the
appliance
Setting the working depth
with the appliance running
causes damage.
■
Only set the working
depth when the motor
and blade system have
stopped.
1. Turn the adjusting wheel (08/1) to HIGH. The
blade system is raised to the maximum.
2. Checking the working depth:
■
Start the appliance (see chapter 6.6
"Starting and stopping the motor (10)",
page 39).
■
Move a little way onto the grass and
check the result. If the grass is too short
or irregularly scarified, the blade system
must be lowered.
3. Stop the appliance and wait until the blade
system has stopped.
4. Turn the adjuster wheel (08/1) a little towards
LOW. The blade system is lowered.
5. Repeat the previous steps until the grass is
uniformly scarified.
COMBI-CARE 36.8 E comfort
Operation