Using The Controls And Connections - Toshiba 36ZP46 Bedienungsanleitung

A wide variety of external equipment can be connected via the sockets located behind the flap on the
television. Do not use the S-Video and Video sockets at the same time. Press the centre of the flap to open it.
Whilst all the necessary adjustments and controls for the television are made using the remote control, the
buttons on the television may be used for some functions.
EXT 5
Switching on
If the power-on light is unlit press the POWER button on
the front of the television to switch the television on, then
press a number button on the remote control to see the
screen.
To put the television into Standby press
control. To view the television press
the number buttons. The picture may take a few seconds
to appear. Standby should only be used for short periods
of time.
To set up the television you will now need to use the on-
screen menus. Press the MENU button on the remote
control to see the top menu bar.
This menu bar `t the top of the screens will show five
different topics shown in symbols. As each symbol is
selected by pressing the S or R button on the remote
control, its respective options will appear below.
To use the options press the Q button on the remote
control to move down through them and OK, S or R to
select the required choice. Follow the on screen
instructions. The functions of each menu are described in
detail throughout the manual.
Connections and controls
i on the remote
i
again or any of

Using the controls and connections

To alter the volume press —
To alter the programme position press
Press MENU and S , R , Q or P to control the sound
and picture options.
Press MENU to finish.
When connecting mono sound equipment to EXT 5,
connect the audio output of the equipment to the
L/Mono socket on the television.
To select the Input, press
EXT 5 as described on page 17. The television will
automatically sense the type of signal.
Please always refer to the owner's manual of the
equipment to be connected for full details.
Please note: Inserting the headphone jack will mute the
sound from all speakers.
8
Green – Timer is set
RED – Power on
Power Button
+
j
.
e e f f
F .
B
until the display shows