Toshiba 36ZP46 Bedienungsanleitung Seite 22

Below are the answers to some of the most common queries.
For more information go to www.toshiba.co.uk
Q
Why is there no sound or picture?
A
Check the mains switch is on and check all
connections.
Check the television is not in standby mode.
Q
There is a picture, but why is there little or no
colour?
A
When using an external source, for instance, a
poor quality video tape, if there is little or no
colour, improvements may sometimes be achieved. The
colour is factory set to AUTO to automatically display the
best colour system.
To check that you have the best colour:
Select Colour from the Set up menu.
1
Set up
Language
Colour
Teletext
EXIT : To exit
With S or R choose between AUTO, PAL,
2
SECAM, NTSC 4. 43 or 3. 58.
Q
Why doesn't the video/DVD being played show
on screen?
A
Make sure the VCR or DVD player is connected to
the television as shown on page 6, then select the
correct input by pressing B
Q
Why is there a good video picture but no sound?
A
Check the SCART lead connection.
Q
Where there is loss of colour, picture or the
position moves, how can this be restored?
A
Switch the television off and wait for the red LED to
extinguish before switching back on. If the problem
persists contact the Helpline.
Q
uestions
ENGLISH
AUTO
.
A
nswers
and
Q
Why is there a picture but no sound?
A
Check the volume has not been turned down or
that sound mute has not been selected.
Q
Why is the VCR/DVD picture in black and
white?
A
Check the correct input has been chosen,
S-VIDEO or AV. See AV connections.
Q
What else can cause a poor picture?
A
Interference or a weak signal. Try a different
television station. Manual fine tuning may help.
Select the Manual tuning menu. Highlight the
1
station and press OK, then press R to select
Manual fine tuning.
Using P or Q adjust to get the best picture and
2
sound. Press OK and then EXIT.
Manual tuning
Manual fine tuning
1 I
OK
MENU
Q
Why doesn't the remote control work?
A
Check the side switch on the remote control is in
TV mode.
Check the batteries aren't dead or inserted incorrectly.
Q
Why don't the controls on the front of the
television work?
A
Check that Panel lock is not ON.
Q
Why is there a message permanently on the
screen?
A
Remove it by pressing CALL.
22
22 + 2 BBC1
M
: To store EXIT : To exit
: To return