Palmer PEPAMPACOUSTIC Bedienungsanleitung Seite 30

WICHTIGER HINWEIS: DER ACOUSTIC POCKET AMP SCHALTET SICH
AUTOMATISCH EIN, WENN DIE EINGANGSBUCHSE (17) BELEGT WIRD. ACHTEN SIE
BEI BATTERIEBETRIEB DARAUF, DASS DER EINGANG UNBELEGT IST, WENN SIE
DAS GERÄT LÄNGERE ZEIT NICHT BENUTZEN, UM EINE VORZEITIGE ENTLADUNG
ZU VERMEIDEN.
CONNECTIONS AND CONTROLS
EN
1) SIGNAL AND PEAK INDICATOR
This LED lights up green when a signal is present at the input. It
turns amber to indicate imminent clipping and flashes red during
occasional peaks. If it stays red lower the instrument's volume or
engage the PAD switch (16) to avoid clipping.
When plugging a cable into the input (17) the Pocket Amp Acoustic
performs a status check (LED red, amber, green for 3 seconds each).
Without an input signal the LED does not illuminate.
2 - 5) EQ SECTION
The 3-band EQ is specifically tuned for acoustic string instru-
ments. The BASS and Highs controls adjust the unit's low and high
frequency response. The MIDS are semi-parametric with individual
LEVEL adjustment and FREQUENCY sweep for precise tone settings.
6) GAIN
This control adjusts the amount of gain depending on the mode
selector (10) position. The GAIN control affects the signal and
peak LED (1).
7) NOTCH
This control attenuates a very narrow frequency band to remove
resonant feedback without affecting the overall sound of the
instrument. It sweeps from 20 Hz (fully CCW, OFF position) to 400
Hz (fully CW), the centre position is 90 Hz.
30