Interrupting Operation; Finish Operation - Kärcher K HC 10 Betriebsanleitung

Start up
Caution
The appliance should only be operated with a
closed battery compartment.
Connect the high pressure hose to the high
pressure connection of the appliance.
Push the spray lance into the trigger gun and
fasten it by turning it through 90°.
Completely open the water tap.
Note: The appliance can be operated two ways
- mains power and battery power.
If the power supply is assured for both the oper-
ating types, the device automatically switches
over to mains operations.
Mains operation
Unwind the mains connection cable all the
way from the hose drum.
Insert the mains plug into the socket.
Turn on the appliance "I/ON".
The displays for battery operation and mains
operation are subjected to a brief test routine
and will illuminate consecutively.
The control lamp "mains operation" glows
green.
The appliance is now ready for operation.
Battery operation
Turn on the appliance "I/ON".
The displays for battery operation and mains
operation are subjected to a brief test routine
and will illuminate consecutively.
The display for battery operation illuminates
continuously and shows the battery status.
The appliance is now ready for operation.
Display battery operation Charging status of
green LED red LED
3 0
2 1
1 2
0 3
0 3 blinking
–
Battery empty: Motor will be switched off, the
three red LEDs will blink another 30 sec-
onds; then the appliance will shut off on its
own.
–
Engine is too hot: Current LED will begin
blinking rapidly, then the appliance will shut
off on its own.
–
If the hand spray gun is not activated for 30
minutes during battery operation, the appli-
ance will shut off on its own.
12
English
the battery pack
70% - 100%
40% - 70%
20% - 40%
10% - 20%
1% - 10%
Operation
Danger
The trigger gun is subjected to a recoil force
when the water jet is discharged. Make sure that
you have a firm footing and are also holding the
trigger gun and spray lance firmly.
Unlock the lever on the trigger gun.
Pull on the lever of the trigger gun; the device
will switch on.
Note: Release the lever of the trigger gun; the
device will switch off again. High pressure re-
mains in the system.
Spray lance with dirt blaster
For particularly dirty items or areas.
Spray lance with pressure regulation
Carrying out the most common cleaning tasks.
The work pressure can be stagelessly regulated
between "Min" and "Max".
Release the lever on the trigger gun.
Turn the spray lance to the desired position.

Interrupting operation

Release the lever on the trigger gun.
Lock the lever on the trigger gun.
During longer breaks (more than 5 minutes),
also turn the appliance off using the "0/OFF"
switch.

Finish operation

Caution
Only separate the high-pressure hose from the
trigger gun or the appliance while there is no
pressure in the system.
Release the lever on the trigger gun.
Turn off the appliance "0/OFF".
Turn off tap.
Detach the appliance from the water supply.
Press the lever on the trigger gun to release
any remaining pressure in the system.
Lock the lever on the trigger gun.
Stow away the accessories on the appli-
ance.
Only after mains operation:
Pull out the mains plug.
Illustration
Wrap the mains power cable around the
storage and attach the mains plug with a ca-
ble clamp.