Technical Data; Cleaning, Maintenance And Ordering Of Spare Parts - EINHELL BPS 600E Bedienungsanleitung

Anleitung BPS 600 E_SPK1:Anleitung LE-ST 360 E SPK1

5. TECHNICAL DATA

Nominal voltage: 230 V ~ 50 Hz
Power consumption:
Cutting rate: 500-3200 min
Stroke height:
Cutting depth in wood:
Cutting depth in plastic:
Cutting depth in iron:
Mitre cuts: up to 45° (left and right)
Sound pressure level L : 89,5 dB(A)
pA
Sound power level L : 100,5 dB(A)
WA
Vibration a 14,35 m/s
w
Double isolation
Weight
6. Cleaning, maintenance and ordering
of spare parts
Always pull out the mains power plug before starting
any cleaning work.
Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts of
the equipment. Ensure that no water can seep
into the device.
Carbon brushes
In case of excessive sparking, have the carbon
brushes checked only by a qualified electrician.
Important! The carbon brushes should not be rep
laced by anyone but a qualified electrician.
Maintenance
There are no parts inside the equipment which
require additional maintenance.
Ordering replacement parts
Please quote the following data when ordering repla-
cement parts:
Type of machine
600 W
Article number of the machine
-1
Identification number of the machine
Replacement part number of the part required
20 mm
For our latest prices and information please go to
65 mm
www.isc-gmbh.info
20 mm
8 mm
7. Disposal and recycling
The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
2
the raw material system.
II /
The unit and its accessories are made of various
2,1 kg
types of material, such as metal and plastic.
Defective components must be disposed of as spe-
cial waste. Ask your dealer or your local council.
08.12.2006 8:47 Uhr Seite 7
GB
7