FAR KJ 45 Bedienungsanleitung Und Ersatzteile Seite 18

ADJUSTMENT OF THE COUPLE TIE ROD/HEAD (fi g. f14-f15-f16)
Changing the length of the insert to clamp, the position of the head (B)
compared to the threaded tie rod (A) should be adjusted.
Disconnect the riveting tool from the compressed-air supply.
Screw an insert of the desired length on the threaded tie rod manually
until the insert head touches the riveting tool head (B). The head is
adjusted correctly if the threaded tie rod comes out of the insert
screwed on it of about 2 mm. Otherwise unblock the ring nut (C) with
a 22 mm standard spanner then screw or unscrew the head (B) up to
the right position, and block the ring nut (C).
ATTENTION!
Disconnect the machine before carrying out the
above-mentioned operations.
A
~2mm
B
18
C
f14
Date 10-2008
GB
f15
C
22 mm
f16
KJ 45 KJ 45
B
Revision - 04