FAR KJ 45 Bedienungsanleitung Und Ersatzteile Seite 17

KJ 45 KJ 45
CHANGE OF SIZE (fi g. f10-f11-f12-f13)
The riveting tool is supplied with 6 pairs of threaded tie rods (A) and heads
(B), for tightening a range of threaded inserts from M4 to M12.
Depending on the insert thread, it is necessary to replace the threaded tie
rod (A) and head (B) group, as follows: loosen the ring nut (C) with a 22
mm. standard spanner and remove the riveting tool head (B), and spacer
(Q) if it ranges from M4 to M8. With the same spanner, unscrew the tube
carrying head (O). Use two 20 mm. standard spanners for disassem
bling the ring nut (K) and extract the threaded tie rod (A).
Note: Use two spanners for unblocking the ring nut (K) as indicated
in fi gure (f9); the inobservance of this procedure can damage the
riveting tool.
After having replaced the threaded tie rod (A) with that one of the right
size, assemble the ring nut (K) again and carry out the above-mentioned
operations in reverse order, being sure that the component (R) is the right
one. Every time you carry out any change of size, repeat the adjustment
operations as indicated at page 18.
ATTENTION!
Disconnect the machine before carrying out the
above-mentioned operations.
B C
22 mm
Revision - 04
GB
22 mm
K
20 mm
M10 - M12
A
B
f10
Date 10-2008
O
M4 ÷ M8
A
B
R
Q
f11
20 mm
Keep
steady
f12
R
f13
17