Technical Data - Ferm PDM1044P Originalbetriebsanleitung

• Before use, remove all nails and other metal
objects from the workpiece.
• Make sure that the workpiece is properly
supported or fixed.
• Keep your hands away from the workpiece
during use.
• Never put the machine down on a table or a
workbench before it has been switched off.
Electrical safety
Always check that the voltage of the
power supply corresponds to the voltage
on the rating plate.
• Do not use the machine if the mains cable or
the mains plug is damaged.
• Only use extension cables that are suitable
for the power rating of the machine with a
minimum thickness of 1.5 mm
extension cable reel, always fully unroll the
cable.

TECHNICAL DATA

Mains voltage
Mains frequency
Power input
No-load speed
Impact rate
Max. drill bit diameter
Protection class
Weight
Noise and vibration
Sound pressure (Lpa)
Acoustic power (Lwa)
Uncertainty (K)
Impact drilling mode
Drill into metal
Uncertainty (K)
Wear hearing protection.
Vibration level
The vibration emission level stated in this
instruction manual has been measured in
accordance with a standardised test given in
EN 60745; it may be used to compare one tool
. If you use a
2
PDM1044P
V~ 220-240
Hz 50
W 850
min-1 0 - 2.600
min-1 0 - 41,600
Wood mm 25
Concrete mm 16
Steel mm 13
IP 20
kg 1.8
PDM1044P
dB(A) 97.7
dB(A) 108.7
dB(A) 3
m/s2 18.64
m/s2 2.98
m/s2 1.5
with another and as a preliminary assessment of
exposure to vibration when using the tool for the
applications mentioned
- using the tool for different applications, or with
different or poorly maintainted accessories,
may significantly increase the exposure level
- the times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work
patterns
DESCRIPTION (FIG. A)
Your impact drill has been designed for drilling
holes in wood, metal and plastics and for hammer
drilling in brick and concrete.
1. On/off switch
2. Lock-on button
3. Speed adjustment wheel
4. Forward/reverse switch
5. Switch for drilling / hammer drilling
6. Chuck
7. Main grip
8. Auxiliary grip
9. Depth stop
10. Chuck key
11. Chuck key holder
ASSEMBLY
Before assembly, always switch off the
machine and remove the mains plug from
the mains.
Mounting and removing the drill bit (fig. B)
The machine is suitable for use of the following
drill bits:
- Wood (HSS)
- Metal (HSS)
- Concrete / masonry (hard metal)
Mounting
• Place the chuck key (10) into one of the holes
in the chuck (6).
5