Changing Light Bulbs; Problem Solving - Teka DPL 110 ISLA Bedienungsanleitung

Adjustment of the clock
1) Push the on/off' button for 3 seconds.
2) Adjust the hour digits by pressing '+' or '-'.
3) Push the on/off' button again.
4) Adjust the minute digits by pressing '+' or '-'.
5) After 3 seconds your settings are saved
automatically.
Filter saturation indicator "F"
When the sign 'Saturation of the filters' is on, the filters
should be cleaned.
After cleaning the filters, simultaneously push "+" and
"-" for at least 3 seconds whereupon the sign will be
switched off.
Cleaning and maintenance
During cleaning and maintenance work, make sure
the safety instructions are complied with
Cleaning the hood body
If your kitchen hood is made of stainless steel,
use proprietary cleaners mentioned in the
product instructions.
• If your kitchen hood is painted, use lukewarm
water and a neutral soap.
• Never use metallic scourers, nor abrasive or
Proceed with the following checks before calling the Technical Service:
Problem
The kitchen hood does not
work.
The kitchen hood does
not extract sufficiently or
vibrates.
When exterior gas extraction is not possible, then the kitchen hood may be set to purify the air
by recycling it through active charcoal filters.
The active charcoal filters have an active life of between three to six months, depending on
the individual conditions of use. These filters cannot be washed nor regenerated. They must be
replaced once their useful life comes to an end.
The manufacturer reserves the right to make changes and corrections to its products as it deems
necessary, without altering their basic characteristics.
•
.

Problem solving

Possible cause
The mains cable is not
connected to the network.
There is no current in the netw
ork.
Filters are saturated with fat.
Obstruction in the air outlet.
Active charcoal filters (Optional)
corrosive products.
• Dry the kitchen hood using a cloth that does not
produce fibres.
• Do not use vapour cleaners.
Cleaning the metal filters
To remove the filters from their fittings, press lightly
on the locks and then pull them off.
The metal filters can be cleaned by soaking them
in hot water with neutral detergent until the fat
dissolves and then rinsing them under the tap
or using special anti-grease products. They can
also be washed in a dishwasher. In this case, it
is advisable to stack them vertically to avoid food
residues to stick to them.
Cleaning in a dishwasher may damage the metallic
surface (blackening it), although this will not affect
its fat retention capacity.
Once clean, leave them to dry off and then fit them
onto the kitchen hood.

Changing light bulbs

For changing the light bulbs please contact the
manufacturer's nearest Technical Service.
Solution
Connect the mains cable to the
Provide current to the network.
Change or clean the active
charcoal and/or metal filters.
Remove the obstruction.
network.