Cleaning And Maintenance; Changing Light Bulbs - Teka DP 985 T Bedienungsanleitung

Instructions for use
You can activate or deactivate the cooker
hood by operating the functions shown in
the diagram.
Switch on the extractor fan a few minutes
before you start to cook in order to ensure
that a steady air flow has been established
before fumes appear.
Allow the extractor fan to run for several
minutes after you have finished cooking in
order to expel all the grease from the outlet
duct. This prevents the return of grease,
smoke and smells.
Display
Increase fan speed
Reduce fan speed
Light
On/off
Adjustment of the clock
1)Push the on/off' button for 3 seconds.
2)Adjust the hour digits by pressing '+' or '-'.
3)Push the on/off' button again.
4)Adjust the minute digits by pressing '+' or '-'.
5)After 3 seconds your settings are saved
automatically.
Program the working time
1) Switch on the cooker hood and choose the
required aspiration speed.
2) Push the '+' and '-' buttons simultaneously
for 1 second. The clock willl disappear and
the digits on the display will start to flash.
3) Choose the required time from 1 to 29
minutes by using the buttons '+' and '-'.
4) The display will alternately show the clock
and the remaining programming time.
The maximum speed 'H' can only be selected
manually and will be automatically changed
to the second speed level after approximately
10 minutes.
Cleaning the metal filters
During cleaning and maintenance
work, make sure the safety instructions
are complied with.

Cleaning and maintenance

•If your kitchen hood is made of stainless
steel, use proprietary cleaners mentioned in
the product instructions.
•If your kitchen hood is painted, use lukewarm
water and a neutral soap.
•Never use metallic scourers, nor abrasive or
corrosive products.
•Dry the kitchen hood using a cloth that does
not produce fibres.
•Do not use vapour cleaners
Cleaning the hood body
•To remove the filters from their fittings,
press lightly on the locks and then pull them
off.
•The metal filters can be cleaned by soaking
them in hot water with neutral detergent
until the fat dissolves and then rinsing them
under the tap or using special anti-grease
products. They can also be washed in a
dishwasher. In this case, it is advisable to
stack them vertically to avoid food residues
to stick to them.
•Cleaning in a dishwasher may damage the
metallic surface (blackening it), although
this will not affect its fat retention capacity.
•Once clean, leave them to dry off and then
fit them onto the kitchen hood.

Changing light bulbs

For changing the light bulbs please contact the
manufacturer's nearest Technical Service.