Changing Light Bulbs; If Something Doesn't Work - Teka GF-T Montageanleitung Und Pflegehinweise

Changing light bulbs

• Remove the filter to access the light bulbs.
• Make sure that the hood has previously
been disconnected from the mains supply
and that the bulbs to be replaced are not
hot.
• The maximum bulb rating is 40 W.
8

If Something Doesn't Work

Before calling the repair service, make the
following checks:
Fault
Hood does not work
Mains cable not connected
Power not reaching plug
Hood not extracting
sufficiently or vibrating
Filter saturated with grease
Obstruction in venting duct
Inadequate venting duct
Lights do not work
Possible Cause Solution
Connect mains cable
Check/repair mains supply
Clean or replace filter
Remove obstruction
Contact installer and follow
the instructions in this manual
Bulbs blown Replace bulbs
Bulbs loose Tighten up bulbs
9